Panasonic AG-HMC40 User Manual - Page 26
The remote control, Insert the battery, Remote control usable range, Turn on/off the camera - screen replacement
UPC - 791871304891
View all Panasonic AG-HMC40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
The remote control Insert the battery 1 Push the catch in the direction shown by arrow ① to remove the holder. 2 Insert the battery with the "+" marked side facing up. Remote control usable range The distance between the remote control and the unit's remote control sensor: Within approx. 5 m Angle: Approximately 15° upward, approximately 10° downward, approximately 15° leftward, or approximately 15° rightward (Except when optional accessories are attached) Remote control sensor 3 Return the holder to its original position. • When the battery (CR2025) has run out, replace it with a new one. (The battery lasts about one year, depending on the frequency of use.) If the remote control unit fails to work even when it is operated near the camera-recorder's remote control sensor, the battery has run out. • Keep the battery out of the reach of children. • The remote control is intended for indoor operation. Outdoors or under strong light, the unit may not operate properly even within the usable ranges. Turn on/off the camera While pressing the lock release button, move the POWER switch to ON or OFF. Turn on the camera: The mode lamp (CAMERA) lights red (camera mode), and the camera enters recording standby mode. Turn off the camera: The mode lamp (CAMERA) goes out. • Energy-saving mode According to the settings made in the POWER SAVE item of the OTHER FUNCTIONS screen in the settings menu, the following will apply if no designated operations* are performed for approximately five minutes in recording standby mode (when an SD Memory Card has been inserted while using the battery). ON: T he camera recorder turns off automatically. OFF: D oes not switch OFF the camera. * S ee the setup menus, POWER SAVE (Page 110) for details. 26 QUICK START CAMERA PB PHOTO POWER Mode lamp QUICK START CAMERA PB PHOTO POWER OFF ON MODE POWER switch Set the POWER switch to the ON position while pressing the lock release button. The CAMERA lamp lights (red), and the camera enters recording standby mode. Lock release button