Panasonic AW-HN40H AW-HN38H Operating Instructions - Page 10
Mount the unit., Check the mounting., On the camera
View all Panasonic AW-HN40H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
How to install and connect the unit (continued) 4 Mount the unit. ●● Align the position of the hole for checking the positioning with the status display lamp. ●● Align the holes on the camera main unit used to insert the bottom panel with the protrusions on the mount bracket used for inserting the camera, push the camera to the bracket firmly, and rotate the main unit by about 15 degrees in the direction of the arrow. ●● Secure the unit to the mount bracket using the main unit mounting screw (M3) as supplied. ●● Attach the mount bracket securely with the prescribed tool using the clamping torque below. Be absolutely sure to verify that none of the screws are loose. Screw diameter M3 Clamping torque 0.78 N · m {8 kgf · cm} Hole for checking the positioning On the mount bracket: Protrusions (x3) used for inserting the camera On the camera main unit: Holes (x3) used to insert the bottom panel Status display lamp Approx. 15° Main unit mounting screw (M3 screw) (with flat washer, spring washer) Notes ●● Do not do this work while holding the camera head since doing so may result in malfunctioning of the unit. ●● Use only the screws supplied. Do not use any other screws. ●● Check that the unit has been mounted securely with no tilting or wobbling. ●● The unit must be secured without fail using the main unit mounting screw before any of the cables are connected. 5 Check the mounting. Check out the following points. • The main unit mounting screw must be mounted securely. • The unit must not tilt, and it must be mounted exactly. • The unit must be securely installed. • The unit pedestal part must not rotate even when an attempt is made to turn it. 10