Panasonic AW-HN40H AW-HN38H Operating Instructions - Page 41

Parts and their functions (continued) iLAN connector for IP control [LINK/ACT] This LAN connector (RJ-45) is connected when exercising IP control over the unit from an external device. Use a cable with the following specifications for the connection to the LAN connector: When connecting through a hub: LAN cable* (category 5 or above), max. 100 meters [328 ft] When using a PoE+ compatible hub: LAN cable* (category 5e or above), max. 100 meters [328 ft] When a hub is not used: LAN cable* (category 5 or above), max. 100 meters [328 ft] *: Use of an STP (shielded twisted pair) cable is recommended. jAnti-theft wire mounting hole Use this hole to attach the wire bracket (commercially available). pRS-422 connector [RS-422] This RS-422 connector (RJ-45) is connected when exercising serial control over the unit from an external device. Use a cable with the following specifications for the connection to this connector. The tally lamp can be lit by shorting the TALLY signal (pin 2) with GND (pin 1). Note ●● Do not apply a voltage to the TALLY signal pin. LAN cable* (category 5 or above, straight cable), max. 1000 meters [3280 ft] *: Use of an STP (shielded twisted pair) cable is recommended. 1357 2468 Pin No. Signal 1 GND 2 TALLY 3 RXD - 4 TXD - Pin No. Signal 5 TXD + 6 RXD + 7- 8- kAudio input connector [AUDIO IN] Inputs external audio (microphone, line). lRS-232C connectors [RS-232C IN/OUT] Connect to RS-232C cables. RS-232C IN/OUT connector 1 2 3 6 4 5 7 8 ● M ini DIN 8-pin (JST) RS-232C IN Pin No. Signal 1 DTR_IN 2 DSR_IN 3 TXD_IN 4 GND 5 RXD_IN 6 GND 7 IR OUT R 8 IR OUT L RS-232C OUT Pin No. Signal 1 DTR_OUT 2 DSR_OUT 3 TXD_OUT 4 GND 5 RXD_OUT 6 GND 7 NC 8 NC Note ●● Be aware that the polarities (+/−) of the serial data may be different depending on the specifications of the device to be connected. qUSB port The unit can be used as a Web camera by connecting the unit and a personal computer with USB Video Class. rmicroSD card slot The video and audio of the camera can be recorded to a microSD card in MP4 format. sThreaded hole (thread: 1/4-20UNC, ISO1222 [6.35 mm]) for mounting the camera Use this hole when mounting the camera on a tripod, etc. tHDMI connector [HDMI] This is the HDMI video signal output connector. mDC IN connector [12V IN ] Connect the AC adaptor supplied with the unit to this connector to supply the DC 12 V voltage to the unit. nCable clamp This is used to hold the cable connection to the DC IN connector and prevent it from becoming disconnected. oGround connector Connects to the ground connector on a wall outlet, ground bar, etc. for grounding. (page 25) Operating Instructions 41