Panasonic AW-HN40H AW-HN38H Operating Instructions - Page 12
When using the WV‑Q105A (optional accessory)
View all Panasonic AW-HN40H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
How to install and connect the unit (continued) ■■When using the WV‑Q105A (optional accessory) It is recommended that you provide an inspection opening or other such space for access purposes in the area near where the equipment is installed in order to facilitate installation and the wiring connections work. Before mounting the mount bracket, check that the installation location is strong enough to withstand the total mass (approx. 2.0 kg [4.41 lb]) which will be exerted once the camera is mounted. When installing the unit on a ceiling, ensure that there is at least 100 mm (3-15/16 inches) of space above the ceiling panel in the place where the unit will be used. The unit can be installed on a ceiling panel with a thickness ranging from 5 mm (3/16 inches) to 40 mm (1-9/16 inches). The drop-prevention wire (supplied with the WV‑Q105A) must be used when mounting the direct ceiling mount bracket. Concrete ceiling Height above ceiling panel: At least 100 mm (3-15/16 inches) Ceiling panel (plasterboard, etc.) with a thickness from 5 mm (3/16 inches) to 40 mm (1-9/16 inches) Anchor bolts ●● Withdrawal strength: 196 N {20 kgf} or more The anchor bolts must not protrude beneath the ceiling panel. ø 60 mm (2-3/8 inches) When installing the unit on a ceiling 1 Refer to the Operating Instructions of the WV‑Q105A direct ceiling mount bracket, and attach the WV‑Q105A as well as the drop-prevention wire angle and drop-prevention wire supplied with the WV‑Q105A to the anchor bolts. Mounting the anchor bolts and direct ceiling mount bracket () This job is facilitated if the direct ceiling mount bracket is loosely secured to the ceiling panel in one place, and the direct ceiling mount bracket and anchor bolts are vertically aligned before the nuts are tightened up. 2 First, remove the screws which were loosely fastened in step 1, and then align the camera mount bracket of the AW‑HN40/AW‑HN38 with the screw holes in the WV‑Q105A direct ceiling mount bracket and mount it in place. ●● Use the mounting screws (the M4-L60 Phillips head screws with adhesive) supplied with the WV‑Q105A as the mounting screws. ●● Fasten the AC adaptor securely to the bottom or other surface of the reinforcing member made of channel steel where dust and other foreign matter will not accumulate. ●● Do not place the AC adaptor directly onto the ceiling panel or other such surface. Space above the ceiling Drop-prevention wire angle (Supplied with WV‑Q105A) Drop-prevention wire (Supplied with WV‑Q105A) Anchor bolts (): Fasten here using the nut. Direct ceiling mount bracket WV‑Q105A (optional accessory) Plasterboard or other ceiling panel Channel steel Inspection opening recommended • The installation and wiring connection work is facilitated if an inspection opening is provided for access purposes. Mounting screws x 4 (Supplied with WV‑Q105A) Camera mount bracket (Supplied with AW‑HN40/ AW‑HN38) (Ceiling panel) AW‑HN40/AW‑HN38 Secure the AC adaptor firmly to a member made of channel steel. 3 Install the AW‑HN40/AW‑HN38 camera by following the procedure starting with step 3 on page 9. 12