Panasonic AW-HN40H AW-HN38H Operating Instructions - Page 39

Concerning the wireless remote control (optional accessory) The unit can be operated by remote control using a wireless remote control (model number: AW‑RM50G) purchased separately. Check out the following points before using the wireless remote control. ●● Point the wireless remote control at the unit's wireless remote control signal light-sensing area (front panel or side panel), and operate it within a range of 10 meters (32.8 ft) from these areas. Refer to shown below. ●● If the unit is installed near fluorescent lights, plasma monitors or other such products or if the unit is exposed to sunlight, the effects of the light may make it impossible for the unit to be operated using the wireless remote control. Be sure to follow the steps below for installation and use. • Take steps to ensure that the wireless remote control signal light‑sensing area will not be exposed to the light from fluorescent lights, plasma monitors or other such products or from the sun. • Install the unit away from fluorescent lights, plasma monitors and other such products. ●● For about 10 minutes even after the batteries have been removed from the wireless remote control, the selection of the operation to be performed (the [CAM1], [CAM2], [CAM3] or [CAM4] button which was pressed last) will remain stored in the memory. When a longer period of time elapses, however, the selection is reset to the status established when the [CAM1] button was pressed. Note ●● The arrows in the figure below show the light-sensing directions in which the wireless remote control signals travel. Wireless remote control signal light-sensing area (side panel, 2 places) Wireless remote control signal light‑sensing area (front panel, 2 places) Operating Instructions ●● Top view (Back) 75° 75° (Front) 45° 45° 39