Panasonic AW-UN70 Operating Instructions - Page 125
Limiters, Basic limiter operations
View all Panasonic AW-UN70 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
Limiters The unit comes with settings (referred to as "limiters") that restrict the panning and tilting movement ranges. Depending on where the unit has been installed, a subject which the user does not wish to be shot may be present in the movement ranges. In a case like this, the unit's shooting range can be limited by setting the limiters at the positions just before the subject which the user does not wish to be shot. The positions of four limiters - namely, the upper, lower, leftmost and right-most limits of the travel range - can be set. Once they have been set, the positions will not be lost even after the power has been turned off. The limiters can be set or released both by the wireless remote control and controller or web setting screen. Whatever was set or released last takes precedence. For the controller operations, refer to the Operating Instructions of the controller. The settings of the limiters using the wireless remote control will be described here. ■■Basic limiter operations 1 Press the [MENU] button. Tap the button (rather than pressing it). When it is pressed for 2 seconds, the camera menu will appear. If this happens, press the [MENU] button again for 2 seconds to clear the camera menu. Then start again from step 1. 2 Press the or [►] button for 2 seconds while holding down the [PRESET] button. The limiter for the upper limit, lower limit, left limit or right limit is set (or released) using these direction buttons, respectively. The tally lamp will blink at this time. When a limiter is set, it blinks once; when a limiter is released, it blinks twice. If any other button was operated between steps 1 and 2, start again from step 1. 125