Panasonic AW-UN70 Operating Instructions - Page 98

Web screen configurations (continued) zzNTP Settings relating to the NTP server address and port No. are performed. This item's setting is reflected when the [Set] button is pressed. NTP server address When [Manual] is selected in the [NTP server address setting], input the IP address or host name of the NTP server. Maximum number of characters 0 to 128 half-size characters Characters that can be Half-size alphanumeric characters, entered half-size symbols :. _ - Factory settings: blank Note ●● To input the [NTP server address] host name, the [DNS] setting must be selected on the [Network] tab of the network setup screen [Network] (page 94). Synchronization with NTP Set whether to use an NTP server by selecting "On" or "Off". Setting value: On Uses an NTP server. (Synchronizes the date and time with the NTP server.) Off Does not use an NTP server. Factory settings: Off NTP server address setting Select the method to acquire the NTP server address. Setting value: Auto Acquires the NTP server address from the DHCP server. Manual Sets the address by inputting the NTP server address in [NTP server address]. Factory settings: Manual Note ●● To acquire the NTP server address from the DHCP server, you need to set "DHCP" (page 93) of "IPv4 network" on the [Network] tab of the network setup screen [Network] to "On". NTP port Input the port No. of the NTP server. Port Nos. that can be selected: 1 to 65535 The following port numbers are used by the unit so they cannot be used. 20, 21, 23, 25, 42, 53, 67, 68, 69, 80, 110, 161, 162, 443, 554, 995, 10669, 10670, 59000 to 61000 Factory settings: 123 Time adjustment interval Selects the interval (1 to 24 hours in 1-hour increments) for acquiring the time from the NTP server. Setting range: 1h to 24h Factory settings: 1h 98