Panasonic AW-UN70 Operating Instructions - Page 71
JPEG transmission, Image capture size, Refresh interval, Image quality, Internet mode over HTTP, Notes
View all Panasonic AW-UN70 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Web screen configurations (continued) There are restrictions on the simultaneous transmission of JPEG and H.264. For details, refer to page 76. zzJPEG JPEG(1) • JPEG(2) • JPEG(3) Configure the settings for JPEG images. Note ●● When the Priority Mode (page 46, page 67) selection is "NDI|HX", "JPEG(2)" and "JPEG(3)" cannot be selected. JPEG transmission Set whether to transmit JPEG images. Factory settings: On Image capture size Select from the following resolutions for the images to be displayed when displaying JPEG images. Setting value: 1920×1080, 1280×720, 640×360, 320×180 Factory settings: JPEG(1): 640×360 JPEG(2): 1280×720 JPEG(3): 320×180 Refresh interval Select the frame rate for JPEG images. Setting value: For 59.94Hz: 5fps, 15fps, 30fps For 50Hz: 5fps, 12.5fps, 25fps Factory settings: JPEG(1): 30fps JPEG(2): 5fps JPEG(3): 30fps Note ●● The frame rate may be slower depending on the network environment, resolution, image quality, access volume, etc. zzH.264(1) • H.264(2) • H.264(3) • H.264(4) Configure the settings for H.264 images. Note ●● When the Priority Mode (page 46, page 67) selection is "NDI|HX", "H.264(3)" and "H.264(4)" cannot be selected. H.264 transmission Whether to transmit the H.264 images is set here. Factory settings: On Internet mode (over HTTP) This setting is selected when transmitting H.264 images over the Internet. H.264 images can be transmitted using the same broadband router settings as when transmitting JPEG images. Setting value: On The H.264 images and audio are transmitted using the HTTP port. For details on setting the HTTP port number, refer to page 95. Off The H.264 images and audio are transmitted using the UDP port. Factory settings: Off Notes ●● When [On] is set, only [Unicast port (AUTO)] can be selected as the [Transmission type] setting. ●● When [On] is set, it takes a few seconds before the H.264 images are displayed. ●● When this is set to [On], H.264 images may not appear depending on the number of users accessing the unit at the same time and whether audio data exists. ●● When this is set to [On], access will be limited to IPv4. ●● When the Priority Mode (page 46, page 67) selection is "NDI|HX", this item is fixed to "Off". Image quality Specify the JPEG image quality (2 types) for each resolution. Setting value: Fine, Normal Factory settings: Fine 71