Panasonic AW-UN70 Operating Instructions - Page 88
Notes, Speed With Zoom POS., Focus Mode, Focus ADJ With PTZ., Tally, IR Control, Factory settings
View all Panasonic AW-UN70 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
Web screen configurations (continued) OIS Set the optical image stabilization function. Setting value: Off Mode1 Mode2 Image stabilization function not used. Image stabilization function used (optical, 2-axis compensation) Image stabilization function used (optical+electronic, 4-axis compensation) Factory settings: Off Notes ●● "Mode2" cannot be selected when HDR is "Low" or "High". ●● "Mode2" cannot be selected when the Priority Mode (page 46, page 67) is "IP(4K)", "SD card(4K)", "USB(4K)", or "HDMI(4K)". ●● When "Mode2" is selected, the view angle changes to set aside image pixels for use during compensation. ●● When "Mode2" is selected, display of the output image is delayed compared to the actual image. ●● Although the image stabilization of "Mode2" (hybrid of optical and electronic compensation) produces stronger compensation than "Mode1", depending on the shooting conditions, it may not be able to differentiate between movement of the subject and movement of the unit as it performs compensation (electronic) on movement detected in the video signal. Therefore, erroneous compensation may occur. ●● The image stabilization setting cannot be changed while data is being written to the SD card. Speed With Zoom POS. "Off" or "On" is set here for the function used to adjust the camera direction's adjustment speed in conjunction with the zoom magnification. When "On" is set, the panning and tilting operations will become slower in the zoom status. This function has no effect during preset operations. Factory settings: On Focus Mode "Auto" or "Manual" is set here for the focusing function. Setting value: Auto The subjects are always brought into focus automatically. Manual The focus is operated manually. Factory settings: Auto Focus ADJ With PTZ. "Off" or "On" is set here for the function which compensates for out-of-focusing when it occurs during panning, tilting or zooming operations at the manual focus setting. This item can be selected only when "Manual" has been selected as the "Focus Mode" setting. Factory settings: Off Tally "Enable" or "Disable" is set here for the function which turns on or turns off the tally lamp using the tally control signal. Setting value: Disable, Enable Factory settings: Enable IR Control "Enable" or "Disable" is set here for operations conducted from the wireless remote control. The operations are enabled when the unit's power is turned on from an external device other than a wireless remote control, and they are disabled when the power is turned on from a wireless remote control. Setting value: Disable, Enable Factory settings: Enable Notes ●● At the point when this item's setting is changed, the new setting is not reflected in operation. It is reflected when the unit is set to standby mode and its power is turned on. ●● Follow one of the procedures below if the item's setting is changed by mistake and the unit can no longer be operated from a wireless remote control. When menu operations can be performed using another control device: First change the item using a control device capable of performing menu operations, and then turn off the unit's power and turn it back on. When menu operations cannot be performed using other control devices: 1. Turn off the power of the units and devices that are connected. 2. Disconnect the unit's AC adaptor cable and LAN cable, and plug them back in. 3. Perform the operation for turning on the unit's power from the wireless remote control. 4. After changing this item, turn off the unit's power and turn it back on. 88