Panasonic AW-UN70 Operating Instructions - Page 44

Camera menu items (continued) ■■System screen This is the menu in which the camera's output image settings are configured. ## System ## Genlock Output Others ■■Genlock screen This unit supports BBS (Black Burst Sync) and tri-level synchronization. External synchronization (genlock) can be applied to achieve phase alignment when multiple cameras are to be used or when the unit is to be used in combination with other devices. ### Genlock ### Horizontal Phase 0 Horizontal Phase Step 1 Return Genlock This displays the Genlock screen on which to perform the phase adjustments. Output This displays the Output screen on which to select the camera's output image settings. Others This displays the Others screen on which to select the settings for the installation status of the camera's pan-tilt head unit and operating speed as well as the settings relating to the other functions. Return Use this to return to the previous menu. Return Horizontal Phase [-206 to +49] This is used to adjust the horizontal phase during genlock. Horizontal Phase Step [1 to 10] This is selected to set the amount by which the [Horizontal Phase] setting is to be adjusted. Return Use this to return to the previous menu. Notes ●● When a cable is connected to the G/L IN connector and a valid synchronization signal is received, the following operations are temporarily halted. • Recording to an SD card • IP image transmission • Output from the HDMI terminal and SDI OUT connectors • Lens control ●● The video signal of the SDI output may be temporarily distorted or may not be output in the following cases. • When the input signal to the G/L IN connector is disrupted or changed. • When a cable is connected to the G/L IN connector or disconnected. 44