Panasonic BT-3DL2550 Operating Instructions - Page 24

Main Menu (continued) 3D Sub menu SYSTEM 3D INPUT TYPE 3D ONLY SIMUL MODE 3D ONLY H MIRROR 3D ONLY H SHIFT 3D ONLY Setting 3D 2D SIMUL LINE BY LINE SIDE BY SIDE LINE BY LINE OVERLAY SDI1(L) SDI2(R) COMPARISON OFF ON -128 - 127 (Factory default: o) Underlined values indicate factory defaults. Description Switches between 2D and 3D Sets monitor to work in 2D mode Sets monitor to work in 3D (spectroscopic) mode Selects the input type in 3D mode. Uses the signals input from SDI1 and SDI2. Ensure that the left-eye signal (L) is connected to SDI1, and the right-eye signal is connected to SDI2 (R). When this input type is selected, the SIMUL MODE noted below becomes active. When SIMUL is selected the input signal from SDI1 is used as the base and a phase difference of up to 15 gs with the SDI2 input signal is allowed. Uses a signal with the left-eye and right-eye signals split line by line. The left-eye signal is displayed on the left hand side of the screen, the right-eye signal on the right side of the screen. A horizontally time compressed signal is used for both. Selects the display method when SIMUL is selected. Displays in 3D (stereoscopic). Mixes and displays the left-eye and right-eye signals. Displays only the signal from SDI1 Displays only the signal from SDI2 Displays the signal input from SDI1 on the left side of the screen, and the signal input from SDI2 on the right side of the screen. Both images are the same size and the aspect ratio is 16:9. The MARKER function is unavailable. This option horizontally inverts the signal from SDI2 when "LINE BY LINE" or "OVERLAY" is selected in SIMUL mode. This can be used when checking left/right signals. Signal not inverted. Signal inverted. Shifts the SDI2 signal horizontally when or is selected in SIMUL mode. The value of this setting is retained until the power is turned off. It is reset to "0" when the power is turned off and then on again. 24