Panasonic Full HD 3D Home Theater Projector Operating Instructions - Page 41

[PICTURE] menu ▲ ▼ Settings [COLOR TEMPERATURE] You can adjust the color temperature if the white areas of the projected image are bluish or reddish. Less bluish Less reddish zzSetting range: -6 to +6 [SHARPNESS] With regards to the input signal, adjust video sharpness using one of [SIMPLE] which adjusts horizontal direction and vertical direction simultaneously or [ADVANCED] which adjusts each individually. Softer Sharper Note zzSetting range will vary according to the selected input signal. zz[SHARPNESS] can be adjusted using either [SIMPLE] or [ADVANCED]. Both settings cannot be used at the same time. zzAdjusting the [SHARPNESS]. (When [SIMPLE] is selected for the [ADJUSTMENT MODE].) 1) Press buttons to select [SIMPLE]. SHARPNESS PICTURE ADJUSTMENT MODE SIMPLE SHARPNESS 0 POSITION H-SHARPNESS V-SHARPNESS LANGUAGE 3D SETTINGS 2) Select L[ESNSHCONATRROL PNESS] with the ▲▼ buttons, aOnPTdIONadjust with the buttons. zzAdjusting the [SHARPNESS]. (When [ADVANCED] is selected for the [ADJUSTMENT MODE].) 1) Press the ◄► buttons to select [ADVANCED]. SHARPNESS PICTURE ADJUSTMENT MODE ADVANCED SHARPNESS POSITION H-SHARPNESS 0 V-SHARPNESS 0 LANGUAGE 3D SETTINGS LENS CONTROL OPTION 2) Select item with the ▲▼ buttons, and adjust with the buttons. zzPressing the ▲▼ buttons on the screen during adjustment switches to the [H-SHARPNESS] or [V-SHARPNESS] adjustment screen. H-SHARPNESS 0 V-SHARPNESS 0 zzThe setting range varies according to the selected picture mode and input signal. [DYNAMIC IRIS] You can switch automatic adjustment of the lamp and the lens iris on/off. This augments the video to create a video expression with sharp contrast between light and shade. Switch settings Switch settings [ON] [OFF] Automatic adjustment No adjustment [WAVEFORM MONITOR] By using a commercial test disk etc. and setting the luminance level of the output (brightness) signal from a connected external device to a value within this projector's recommended range, you can perform adjustment so the display performance of the projector can be fully leveraged. 1) Press the button. zzThe [WAVEFORM MONITOR] menu is displayed. WAVEFORM MONITOR OFF FULL SCAN(Y) FULL SCAN(R) FULL SCAN(G) FULL SCAN(B) SINGLE LINE SCAN(Y) SINGLE LINE SCAN(R) SINGLE LINE SCAN(G) SINGLE LINE SCAN(B) MONITOR POSITION AUTO ADJUST UPPER LEFT 2) Press the ▲▼ buttons to select the required item. zzSelect [OFF] to close the waveform monitor. 3) Press the button. zzThe waveform monitor is displayed. Note zzFor details, see "Displaying the waveform monitor" in "Remote control operation". ( page 33) ENGLISH - 41