Panasonic Full HD 3D Home Theater Projector Operating Instructions - Page 80
[sleep], [high Altitude Mode
View all Panasonic Full HD 3D Home Theater Projector manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
[OPTION] menu • [BLANK] When [BLANK] is activated, output is 12 V. If the setting is released, output is 0 V. • [RS-232C COMMAND LINK] Receives commands ( page 103) from external device and outputs 12 V. zz Input [POWER ON/OFF] [BLANK] • [POWER ON/OFF] If the trigger input signal from the external device is changed from 0 V to 12 V, the projector power will be switched on. And if it is changed from 12 V to 0 V, the power will be switched off. • [BLANK] If the trigger input signal from the external device is changed from 0 V to 12 V, the screen will go blank. And if it is changed from 12 V to 0 V, the [BLANK] setting will be released. 3) Press the buttons to move the cursor to [DELAY TIME] 4) Press the ◄► buttons to set the delay time for the trigger output signal zzThe delay time can be set to 2, 4, 6, 8, 10, 20, and 30 seconds. zzIt is possible to delay the trigger output signal (12 V) by the amount of time set. (Only available if trigger output item is selected.) E.g.)Select [SELECT 4:3 ASPECT] of the trigger output function and set the delay time to 10 seconds.  Set the [ASPECT] in the [POSITION] menu to [4:3], and 12V is output from the trigger port after 10 seconds. Note zzYou should not use trigger terminal output as the power source for other devices. zzThe projector will not accept trigger input while preparing to project after the power has been switched on and while preparing to shutdown after projection. Input trigger signals after projection starts or after entering standby mode. zz12 V cannot be output from the trigger terminal when the projector is in standby mode. [SLEEP] Set the time for the power to be automatically turned off. Switch settings Switch settings [OFF] [60MIN.] [90MIN.] [120MIN.] [150MIN.] [180MIN.] [210MIN.] [240MIN.] Inactive Turn power off after 60 minutes Turn power off after 90 minutes Turn power off after 120 minutes Turn power off after 150 minutes Turn power off after 180 minutes Turn power off after 210 minutes Turn power off after 240 minutes Note zzThe projector automatically enters power off preparation mode (the power indicator illuminates orange), and then enters standby mode (the power indicator illuminates or flashes in red). ( page 28) zz3 minutes before turn-off, the number of minutes remaining will be displayed in the lower right corner. zzIf [SLEEP] mode is set to [OFF] mode before the specified time has elapsed the settings are erased. [HIGH ALTITUDE MODE] Set to [ON] when using at locations between 1 400 m (4 593 ft) and 2 700 m (8 858 ft) above sea level. Switch settings Switch settings [OFF] [ON] When using at an altitude of less than 1 400 m (4 593 ft) above sea level When using at high altitudes (between 1 400 m (4 593 ft) and 2 700 m (8 858 ft) above sea level) Note zzThe fan rotation and operating noise increases if set to [ON]. Settings 80 - ENGLISH