Panasonic PT-D6000ULK Operating Instructions - Page 31

J Replacement procedure Q Removing and replacing the lamp unit 1. Use a Phillips-head screwdriver to loosen the 1 lamp unit cover fixing screw on the back of the projector until the screws turn freely, and remove the lamp unit cover. Slide the lamp unit cover to the buttons and pull to remove. Lamp unit cover fixing screw Replacement 4. Hold the handle of the new lamp unit and replace it in correct direction. 5. Press in the lamp unit until it clicks and make sure the unit is installed securely. 6. Tighten the 3 lamp unit fixing screws securely with a Phillips-head screwdriver. Fan electric power connector Lamp unit cover 2. Use a Phillips-head screwdriver to remove the 3 lamp unit fixing screws. 3. Hold the handles of the lamp unit and pull the used lamp unit gently from the projector. Lamp unit screws Handle 7. Attach the lamp unit cover and tighten the 1 lamp unit cover fixing screw securely with a Phillipshead screwdriver. Slide the lamp unit cover to the hinge side and push in to attach securely. Make sure the fan electric power connector of the lamp unit cover is inserted securely to the projector's connector. Handle Lamp unit screws Replacing the Auto Cleaning Filter (ACF) J Before replacing the ACF Wait until the cooling fan stops and turn off the POWER switch of the projector in proper way. Disconnect the power cord from the wall outlet. Contact an Authorized Service Center to purchase a replacement ACF (ET-ACF100). J When to replace the ACF The ACF unit is consumable product and effects on ventilation. The FILTER indicator will inform you of the replacement timing. You can check the remaining amount of the ACF unit in REMAINING FILTER of STATUS in PROJECTOR SETUP menu. Maintenance ENGLISH - 31