Panasonic VDR M70 Operating Instructions - Page 149

During recording Symptom Cause and Correction Pressing the REC button Is input image copy guarded? Copy-guarded image cannot be will not start recording recorded on this DVD video/camera. liecording starts but stops immediately. Is disc scratched or does dirt or fingerprint adhere to it? Clean the disc. If there is still no improvement, replace the disc. Reference page i , --I --- 20 I 1 i i. Is some other AV device directly connected to the video/audio input/output jack of this DVD video camera/recorder? If the AV device is connected via several other devices, such as AV selector, the video signal may not be transmitted incorrectly. In such a case, reduce the number of devices through which the video signal is transmitted, or connect AV device directly. Are you attempting to record an image from a video game or PC? From some video games or PCs, images cannot be recorded on this DVD video camera/recorder. Some vibrations are felt These vibrations or sound are caused by disc drive: This does not or slight sound is heard indicate a fault. from mechanism. LCD screen is hard to Has brightness of LCD screen been adjusted? see. Stop recording and adjust the brightness. 86 Is the DVD video camera/recorder being used outdoors? Use the viewfinder. When using LCD monitor, adjust its angle so that 37 LCD screen is not exposed to direct sunlight. Focus is not correct. Is it difficult to use auto focus with your subject? Focus manually. 63 Does "MF" appear? The DVD video camera/recorder is set to manual focus. Focus the 63 subject manually, or release manual focus. Is the dioptre control correctly adjusted if you are using the viewfinder as a monitor? 36 Adjust the dioptre control. In cases other than the above, set the power switch to "OFF", and then set it to "iiiii VIDEO", "0 PHOTO" or "Cfg1:1 PHOTO" again. 49 Some vibrations are felt These vibrations or sound are caused by disc drive: This does not or slight sound is heard indicate a fault. from mechanism.