Panasonic VDR M70 Operating Instructions - Page 151

When the DVD video camera/recorder is connected to PC: Symptom Cause and Correction No drive icon appears on The DVD video camera/recorder is not turned on. PC. , Check the power supply. Driver is not properly recognised I um I 'C olf and on again. If the drive icon still does i rol appear, use "Refresh driver- in Device Manager to reinstall the driver. Turn PC off and then disconnect the USB cable, 1um PC on again, and then use the USD cable to connect the DVD video camera/ recorder to PC. IVHke suit the USB cable is completely plugged into this DVI ) video camera/recorder. If a yellow "I" mark is attached to :mine device in Windows Device Manager. uninstall the USB device driver, and then reinstall it. following the procedure on page 128. rror occurs in playback If error occurs with USB connection, the transfer rate is not sufficient. of DVD video camera/ recorder on PC. Application is not normally run on PC . lunt the PC and DVD video camera/recorder off, and try again. Error occurs dur ing writing to DVD-11 disc. I l ie temperature of DVD video calnom/recorder is too high due to continuous operation. IA:room-loci the DVD video camera/recorder from PC once, remove the disc from the DVD video camera/recorder, and then turn it off. After a few moments, connect them again and write to a brand-new disc. Transfer of images stops. Connect the DVD video cal nera/recorder to another USB terminal of PC. If your PC is a desktop type. it is recommended that you use USB terminal on the back of I 'C. I NI Ir I tAM/R/RW drive I mill kilo PC cannot be used after the provided software has been installed. This problem may be solved it the software related to DVD-RAM/11/ RW of your PC is upgraded, or if the DVD-RAM driver is uninstalled. However. with Windows" 98 Second Edition / Me / 2000 Proiessional. uninstalling the DVD-RAM driver will make it impossible for the JPEG stills recorded on DVD-RAM of this DVD video carnera/recorder to be read by the PC. DVDd disc cannot be played back on DVD Movie.AlbumSE. DVD-MovieAlburnSL does not support playback or data read on DVD-R disc: Use generally available DVD video playback software to play back DVD-R disc on PC. Error appears when starting DVDMovieAlbumSE. Make sure that your PC display adapter (video card) conforms to DirectX 8, 1 . Video written to hard disk DVD-MovieAlbumSE cannot edit DVD-VR data stored on lord disk of PC cannot be edited of PC: Copy the data to another DVD-RAM disc and then edit it. on Dv D-MovicAlburn copy tool. Movies are not recognised by application in PC. Make sure the power switch of this DVD video camera/recorder is set to "al VIDEO", PHOTO" or "H":1 PHOTO". Tile Dibolliffibiiiuit on While the DVD video camera/recorder is connected 10 PG, use is not valid when the DVD Explorer to right-click the DVD videocamera/recorderdrive icon and video camera/recorder is execute "Eject". connected to PC. Reference page el 9 131