ProForm Fusion 6.0 Lx English Manual - Page 5
Assembly - system manual
View all ProForm Fusion 6.0 Lx manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
ASSEMBLY Make Assembly Easier for Yourself Everything in this manual is designed to ensure that the weight system can be assembled successfully by almost anyone. Before beginning assembly, make sure to read the information on this page. This brief introduction will save you much more time than it takes to read it. parts of the weight system in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. The included Allen wrench and grease, and the following tools (not included) may be required for assembly: • Two adjustable wrenches • One standard screwdriver Hire an Authorized Service Technician To hire an authorized service technician to assemble the weight system, call toll-free 1-800-445-2480. • One phillips screwdriver • One rubber mallet • A small amount of soapy water, and clear tape or masking tape. Assembly Requires Two Persons For your convenience and safety, assemble the weight system with the help of another person. Set Aside Enough Time Assembling the weight system may require several hours. By deciding to make the task enjoyable, assembly will go smoothly. You may want to assemble the weight system over a couple of evenings. Note: Assembly may be more convenient if you have a socket set, a set of open-end or closed-end wrenches, or a set of ratchet wrenches. How to Identify Parts To help you identify the small parts used in assembly, we have included a PART IDENTIFICATION CHART in the center of this manual. Note: Some parts may have been pre-attached. If a part is not in the parts bag, check to see if it has been pre-attached. Select a Location for the Weight System Because of its weight and size, the weight system should be assembled in the location where it will be used. Make sure that there is enough clearance to walk around the weight system as you assemble it. How to Orient Parts As you assemble the weight system, make sure all parts are oriented exactly as shown in the drawings. Tightening Parts How to Unpack the Box To make assembly as easy as possible, we have divided the assembly process into four stages. The parts needed for each stage are found in individual bags. Important: Wait until you begin each stage to open the parts bag for that stage. Place all Tighten all parts as you assemble them, unless instructed to do otherwise. Questions? If you have questions after reading the assembly instructions, see the front cover of this manual. The Four Stages of the Assembly Process Frame Assembly-You will begin by assembling the base and the uprights that form the skeleton of the weight system. Cable Assembly-During this stage you will attach the cables and pulleys that connect the arms to the weights. Arm Assembly-During this stage you will assemble the arms and the moving parts. Seat Assembly-During the final stage you will assemble the seats, the backrests, and other parts. 5