Sharp FO-2080 FO-2080 Operation Manual for General Use - Page 66

USER SETTINGS Program number Program name 11 2-SIDED COPY MODE 12 MARGIN WIDTH 13 MEM. FOR PRINTER 14 AUTO KEY REPEAT 15 KEY PRESS TIME 16 KEY TOUCH SOUND 17 SOUND AT DEFAULT 18 TONER SAVE MODE Setting codes (factory default setting appears in bold) 1: HI-SPEED 2: NORMAL 1: 1/4" 2: 1/2" 3: 3/4" 4: 1" 1: 30% 2: 40% 3: 50% 4: 60% 5: 70% 1: ON 2: OFF 1: NORMAL 2: 0.5 SEC. 3: 1.0 SEC. 4: 1.5 SEC. 5: 2.0 SEC. 1: LOW 2: HIGH 3: OFF 1: ON 2: OFF 1: ON 2: OFF Explanation • If the memory fills up when two-sided copying is performed, "NORMAL" can be selected to make copying possible. However, "NORMAL" results in a slower copying speed. Normally "HISPEED" is selected to enable fast two-sided copying. • Use this setting to set the margin width. • Use this to change the proportion of machine memory used for printer mode. • Use this setting to select whether or not holding down a key causes repeated input of the key. For keys that normally cause a set value to decrease or increase when held down (for example, the [ ] key ( ) or [ ] key ( )), this program can be used to have the set value not change when the key is held down. • Use this setting to select how long a key must be pressed for the input to be accepted. By selecting a longer time, you can prevent settings from being changed by the accidental pressing of a key. • This sets the volume of beep signals. (p.68) • Use this to sound a beep when a base setting is selected. (p.68) • This mode reduces toner usage by about 10% when copying. Toner save mode is effective when the exposure mode is AUTO or TEXT. 64