Sharp MX-C312 Operation Guide - Page 218

COPIER GENERAL PROCEDURE FOR USING STAMP To select stamp settings, follow the steps below. Place the original. Place the original face up in the document feeder tray, or face down on the document glass. When using this function with a portrait original on the document glass, place the original so that the top of the image is to the right. abc 1 Top of image to the right After placing the original, specify the original size. ☞ ORIGINAL SIZES (page 2-29) Select the special modes. 2 (1) Touch the [Special Modes] key. (2) Touch the [Stamp] key. ☞ Special modes menu (1st screen) (page 2-40) Special Modes Stamp Date Page Numbering Stamp Text OK Cancel OK 1 3 6 2 2 5 1 4 Layout 3 Select the print position. Select from 6 positions: top left, top center, top right, bottom left, bottom center, bottom right. You can also skip this step and go directly to the next step. In this case, the stamp items will be printed in the following positions: Date: Top right Stamp: Top left Page Numbering: Bottom center Text: Top left Print positions The keys that show the print positions will appear as follows depending on the state of the settings. Not selected, stamp setting has not 1 been selected. Selected during selection of the stamp 1 setting. Not available, stamp setting has already 1 been selected. • "Date" and "Page Numbering" cannot be selected in multiple positions. If the [Date] key or [Page Numbering] key is touched when "Date" or "Page Numbering" has already been selected for a position, a message will appear asking you if you wish to move that item to the selected position. To move the item, touch the [Yes] key. Otherwise, press the [No] key. • If you attempt to set "Date", "Text", or "Page Numbering" in a position where one of these items is already set, a message will appear. To change the previously selected item to the new item, touch the [Yes] key. To keep the previous item, touch the [No] key. 2-59 Contents