Sharp MX-C312 Operation Guide - Page 97

BEFORE USING THE MACHINE Remove the developer cartridge. (1) Grasp the developer cartridge lock and pull it forward and down. (2) Squeeze the lever on the developer cartridge (3) (3) Pull the developer cartridge out (2) (2) 4 horizontally. Roller (4) Support the developer cartridge near the middle with your hand and completely remove the developer cartridge. • When removing the developer cartridge, grasp it with both hands at the middle. • Try to keep the developer cartridge horizontal as you remove it. If tipped during removal, developer may spill out. • There will be toner on the roller area of the removed developer cartridge. Do not touch the roller area. If you accidentally touch the toner, immediately wash your hands. Protective material Shake the new developer cartridge 5 or 6 times as shown. Hold the developer cartridge firmly as shown below and shake forward and back, left and right. Remove the protective material after shaking the developer cartridge. • The part of the developer cartridge shown in the next illustration is easily deformed or damaged. Do not touch this part when handling the cartridge. • Do not touch the roller in the developer cartridge. If the roller is accidentally touched, 5 image problems may result. In that case, replace the developer cartridge with a new cartridge. • The seal must not be removed when shaking the new developer cartridge. • Take care not to damage the developer cartridge when shaking it. If damaged, the developer in the cartridge may leak out. 1-56 Contents