Sharp MX-C312 Operation Guide - Page 694

SYSTEM SETTINGS Device Control These settings control devices installed on the machine. Touch the [Device Control] key to configure the settings. Other Settings AB/Inch Type Setting The numbers and units of the default settings and input ranges that appear in the setting screens can be switched between inches and AB sizes. Default Original Size Settings Specify this setting when a particular original size is frequently used. The setting will appear in the [Original] key. Specifying this setting allows the original size setting to be omitted. Mode Settings Copy None, A5, B5, A4, 216mm x 330mm (8-1/2" x 13"), 8-1/2" x 13-2/5" (216mm x 340mm), 216mm x 343mm (8-1/2" x 13-1/2"), 8-1/2" x 11", 8-1/2" x 14", 5-1/2" x 8-1/2", 16K Image Send None, A5, B5, A4, 216mm x 330mm (8-1/2" x 13"), 8-1/2" x 13-2/5" (216mm x 340mm), 216mm x 343mm (8-1/2" x 13-1/2"), 8-1/2" x 11", 8-1/2" x 14", 5-1/2" x 8-1/2", 16K, Long Size Scan to HDD None, A5, B5, A4, 216mm x 330mm (8-1/2" x 13"), 8-1/2" x 13-2/5" (216mm x 340mm), 216mm x 343mm (8-1/2" x 13-1/2"), 8-1/2" x 11", 8-1/2" x 14", 5-1/2" x 8-1/2", 16K, Long Size When [None] is selected, the original size does not appear and must always be set manually. Original Feeding Mode The following original feeding modes can be set to operate by default in copy, Scan to HDD, and image send modes. When a mode is frequently used, this saves you from having to select the mode in the special modes each time you need to use it. • Mixed Size Original (Same Width (Copy mode only)) • Slow Scan Mode Auto Paper Selection Setting The paper types* that the Auto Paper Selection function will select can be specified. Select one of the following settings: • Plain Paper • Plain and Recycle Paper • Recycle Paper The Auto Paper Selection function will not select any paper types other than the paper types specified with this setting. * The paper type set for each paper tray using "Paper Tray Settings" (page 7-13) in the system settings (general). Detect Standard in Auto Color Mode When the color mode is set to auto in copy mode, the discrimination point for detecting whether originals are color or black and white can be set to one of 5 levels. To make it easier to detect a black and white original, adjust the setting toward [Black & White]. To make it easier to detect a color original, adjust the setting toward [Color]. Registration Adjustment If the colors are out of place on the printed surface when color printing is performed, the print positions of the colors can be adjusted. To perform this adjustment, touch the [Auto Adjustment] key. A message will appear. Touch the [Execute] key. 7-65 Contents