Sharp MX-C312 Operation Guide - Page 98

BEFORE USING THE MACHINE Insert the new developer cartridge horizontally. Insert the new developer cartridge in the same location as the cartridge that was removed. 6 • Do not tilt the developer cartridge or insert it in the wrong direction or orientation. This may damage the developer cartridge or drum cartridge and cause failure. • When inserting the developer cartridge, grasp it with both hands at the middle. • Do not remove the seal from the developer cartridge until the cartridge is installed in the machine. If the seal is removed when the cartridge is not locked, the cartridge may fall out of the machine. Insert with the arrow on the cartridge aligned with the arrow on the machine. Peel the seal edge off from the developer cartridge. Align the V-shape cut out of the seal with the attachment tab while peeling it off. Take care not to peel the seal off completely. 7 Grasp the developer cartridge lock and replace it on the machine. 8 Hold the developer cartridge with one hand and slowly remove the seal with the other hand. Slowly pull the seal straight and horizontally out. 9 If excessive force is used or the seal is pulled out diagonally, it may tear. There is a mark (red belt) on the end of the seal. After removing the seal, be sure to verify that the mark (red belt) is on the end of the seal. If the seal has been cut on the developer cartridge, the cartridge cannot be used. Replace with a new developer cartridge. 1-57 Contents