Sony HTCT500 Operating Instructions - Page 98

• If you resume playing a disc when volume is maximum, there may be no sound. In this case, turn down the volume, turn off the system and then turn it on again. Sound is interrupted or there is noise. • Check the output audio formats supported by this system (page 100). There is no picture or an unclear picture appears on the TV screen. • Check that the TV is selected correctly. • Set the TV to the appropriate input mode. • Move your audio components away from the TV. • If a video signal other than those supported by the system is input, the image may be distorted. • The resolution setting may not be appropriate. Use the "RESOLUTION" menu in the system menu to change the resolution setting until the picture on the TV screen is satisfactory (page 95). • The GUI menu does not appear properly when the resolution of the HDMI-connected component's video output is set to 480i or 576i. In this case, adjust the resolution of the component's video output to 480p or 576p, or higher. The source image (input via the HDMI jack) on the subwoofer is distorted, interrupted or not output from the TV. • Check the HDMI connection. • Depending on the playback component, you may need to set up the component. Refer to the operating instructions of each component. • Use a High Speed HDMI cable. If you use a Standard HDMI cable, 1080p or Deep Color images may not be displayed properly. • Depending on the HDMI-connected component, the image on the TV screen may be distorted. In this case, set the [Video Direct] setting in the [HDMI] menu to [ON] (page 83). There is a picture on the TV screen but no sound. • Check that the audio assignable setting is correct (page 81). Control for HDMI The Control for HDMI function does not work. • Check the HDMI connection (page 27). • Make sure [Control for HDMI] is set to [ON] in the GUI menu. • Make sure the connected component is compatible with the Control for HDMI function. • Check the Control for HDMI settings on the connected component. For details, refer to the operating instructions of the component. • If you change the HDMI connection, or connect/disconnect the AC power cord (mains lead), or if there is a power failure, repeat the procedures of "Preparing for the "BRAVIA" Sync" (page 60). • The system may not work correctly if you select a component that is not compatible with the Control for HDMI function on the TV side. No sound is output from the system and the TV's speaker. • Check the volume of the system and the TV. • Select the input of the system correctly. The sound is output from both the system and the TV. • If the Control for HDMI function is set to off, or the selected component is not compatible with the Control for HDMI function, turn off the sound of the system or the TV. The System Power Off function does not work. • Change the setting of the TV to turn connected components off automatically when you turn off the TV. For details, refer to the operating instructions of the TV. An image does not appear on the TV. • Check whether HDMI IN and HDMI OUT are connected correctly. 98US