Sony HTCT500 Operating Instructions - Page 99

When the system is in standby mode, there is no image or sound on the TV. • When the system is in standby mode, image and sound are output from the HDMI component selected the last time you turned off the system. To enjoy another component, play the component and perform the OneTouch Play operation, or turn on the system to select the HDMI component you want to enjoy. • Make sure [HDMI Pass Through] is set to [ON] in the GUI menu if you connect components not compatible with the "BRAVIA" Sync to the system (page 65). S-AIR function Sound transmission is not established. • If you use another S-AIR main unit, place it more than 8 m (about 25 feet) away from the system. • Confirm that the S-AIR IDs of the subwoofer and the S-AIR sub unit are the same (page 87). • Another S-AIR sub unit is paired to the S-AIR main unit. Pair the desired S-AIR sub unit with the S-AIR main unit (page 90). • Place so that the S-AIR main unit and S-AIR sub unit are separated from other wireless devices. • Avoid using any other wireless devices. • The S-AIR sub unit is turned off. Make sure the AC power cord (mains lead) is connected and turn on the S-AIR sub unit. No sound is heard from the S-AIR product. • If you use another S-AIR main unit, place it more than 8 m (about 25 feet) away from the S-AIR main unit you are using. • Confirm that the S-AIR IDs of the subwoofer and the S-AIR sub unit are the same (page 87). • Check the pairing setting (page 90). • Place the S-AIR main unit and S-AIR sub unit closer together. • If you are using any equipment that generates electromagnetic energy such as a microwave oven near an S-AIR product, turn off the equipment and try using the S-AIR product again after waiting for a short time. • Avoid using any other wireless devices. • Change the [RF Change] setting (page 92). • Change the ID settings of the S-AIR main unit and S-AIR sub unit. • Turn off the system and S-AIR sub unit, then turn them on again. • The system does not support S-AIR devices other than S-AIR receivers. • Wireless surround amplifiers cannot be used with this system. There is noise or the sound skips. • If you use another S-AIR main unit, place it more than 8 m (about 25 feet) away from the S-AIR main unit you are using. • Sources with copyright protection may not be playable on S-AIR receivers. • Place the S-AIR main unit and S-AIR sub unit closer together. • If you are using any equipment that generates electromagnetic energy such as a microwave oven near an S-AIR product, turn off the equipment and try using the S-AIR product again after waiting for a short time. • Place so that the S-AIR main unit and S-AIR sub unit are separated from other wireless devices. • Avoid using any other wireless devices. • Change the [RF Change] setting (page 92). • Change the ID settings of the S-AIR main unit and S-AIR sub unit. Other The remote does not function. • Make sure that the connectors for the remote control are connected to each REMOTE CTRL jack of the subwoofer and the speaker. • Point the remote at the remote sensor in the front panel display of the subwoofer or the speaker. continued 99US Additional Information