Stihl FS 460 C-EM Product Instruction Manual - Page 23

Mounting the Cutting Attachment Preparing the machine N Lay down the machine so that the mount for the cutting attachment faces upward Attaching the thrust plate 2 1 3 4 N Push the thrust plate (1) and guard washer (2) onto the shaft (3) The machine is equipped at the factory with a guard ring (4) for mowing tools. The thrust plate (1) on the gearbox is required for securing all cutting attachments. FS 460 C-M, FS 460 C-M L 002BA407 KN 002BA406 KN English The guard washer (2) on the gearbox is required for securing all cutting attachments with the exception of circular saw blades. Mounting the cutting attachment Use the appropriate deflector for the cutting attachment - see "Mounting the deflector". Mounting the mowing heads STIHL SuperCut, STIHL AutoCut, STIHL TrimCut, STIHL PolyCut N Use the guard ring for mowing tools N Attach the deflector for mowing heads 1 N Block the shaft N Turn the mowing head counterclockwise onto the shaft (1) and tighten 002BA408 KN Remove the tool used to block the shaft. Keep the information sheet for the mowing head in a safe place. Removing the mowing head N Block the shaft N Unscrew the mowing head clockwise Feeding out mowing line A detailed description is contained in the information sheet for the respective mowing head. SuperCut Mowing Head Line is fed out automatically during mowing and shortened to optimum length by the blade on the deflector. Line is fed out only if both ends of the line are still at least 6 cm long. AutoCut Mowing Head N Hold the machine over an area of lawn with the engine running (mowing head must rotate) N Tap the mowing head on the ground - line is fed out automatically and shortened to optimum length by the blade on the deflector Line is fed out only if both ends of the line are still at least 2.5 cm long. TrimCut Mowing Head Always switch off the engine to fed out mowing line by hand - otherwise there is a risk of injury! 21