Stihl FS 460 C-EM Product Instruction Manual - Page 37
Replacing a broken starter rope, Tensioning the rewind spring, take care to avoid the risk of,
View all Stihl FS 460 C-EM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
English 9926BA028 KN 4 5 6 7 N Carefully remove the rope rotor (4) with carrier (5), pawls (6) and washer (7). N Put the carrier (5) down so that the pawls and washer cannot fall out. The rewind spring may pop out and uncoil during this operation - take care to avoid the risk of injury. Replacing a broken starter rope N Remove the remaining rope from the rotor and starter grip. 9926BA025 KN 1 2 N Thread the rope through the top of the guide bushing (1) and rope rotor (2). 9926BA027 KN 3 4 5 5 N Fit the E-clip (3) in the groove in the starter post. N Push the spring clip (4) into position - it must point counterclockwise as shown and engage the pegs on the pawls (5). Tensioning the rewind spring 9926BA029 KN 9926BA035 KN N Thread the new rope through the starter grip and tie one of the knots shown. N Pull the knot back into the grip. 9926BA026 KN N Coat starter post uniformly with STIHL gear lubricant - see "Special Accessories". N Slip the rope rotor with carrier, pawls and washer over the starter post - turn it back and forth to engage the anchor loop of the rewind spring. N Make a loop in the unwound starter rope and use it to turn the rope rotor six full revolutions counterclockwise. N Hold the rotor steady. N Pull out and straighten the twisted rope. N Release the rope rotor. N Release the rope slowly so that it winds onto the rotor. FS 460 C-M, FS 460 C-M L 35