Stihl FS 460 C-EM Product Instruction Manual - Page 28

English Checking for proper closure Fitting the Full Harness Fitting the full harness is described in detail in the instruction sheet supplied. 001BA227 KN 001BA223 KN 1 Left: Base of improperly aligned cap (with open space) N The lug on the grip must engage entirely in the recess (arrow), and the grip must lie completely flush with the top of the cap. Right: Base of cap correctly positioned for installation 002BA411 KN 001BA226 KN 2 3 001BA225 KN N Grip the cap and check for tightness. N If the cap can be moved, it is not properly installed. Misalignment of the cap parts N If the cap does not drop fully into the opening when the positioning marks line up and/or if the cap does not tighten properly when twisted, the base of the cap may be rotated out of position vis-à-vis the top. N Such misalignment can result from handling, cleaning or an improper attempt at tightening. N To correct a misalignment, turn the cap (with the grip up) until it drops fully into the tank opening. N Twist the cap counterclockwise as far as it will go (approx. 1/4 turn) - this will twist the base of the cap into the correct position. N Twist the cap clockwise, closing it normally - see the sections "Closing" and "Checking for proper closure." N If your cap still does not tighten properly, it may be damaged or broken; immediately stop use of the unit and take it to your authorized STIHL dealer for repair. N Put on the full harness (1). N Adjust the length of the strap so that the carabiner (2) is about a hand's width below your right hip. N Attach the spring hook to the machine's perforated strip (3). Find the right attachment point for the cutting attachment you are using - see "Balancing the Brushcutter". 26 FS 460 C-M, FS 460 C-M L