TP-Link T1500-28PCT T1500-28PCTTL-SL2428PUN V3 User Guide - Page 389

Configuring LLDP LLDP Configurations Switch(config)#lldp timer tx-delay 2 Switch(config)#lldp timer reinit-delay 3 Switch(config)#lldp timer notify-interval 5 Switch(config)#lldp timer fast-count 3 Switch(config)#show lldp LLDP Status: Enabled LLDP Forward Message: Disabled Tx Interval: 30 seconds TTL Multiplier: 4 Tx Delay: 2 seconds Initialization Delay: 2 seconds Trap Notification Interval: 5 seconds Fast-packet Count: 3 LLDP-MED Fast Start Repeat Count: 4 Switch(config)#end Switch#copy running-config startup-config 2.2.2 Port Config Select the desired port and set its Admin Status, Notification Mode and the TLVs included in the LLDP packets. Step 1 Step 2 Step 3 Step 4 Step 5 configure Enter global configuration mode. interface {fastEthernet port | range fastEthernet port-list | gigabitEthernet port | range gigabitEthernet port-list | ten-gigabitEthernet port | range ten-gigabitEthernet port-list ] Enter interface configuration mode. lldp receive (Optional) Set the mode for the port to receive LLDP packets. It is enabled by default. lldp transmit (Optional) Set the mode for the port to send LLDP packets. It is enabled by default. lldp snmp-trap (Optional) Enable the Notification Mode feature on the port. If it is enabled, the local device will send trap messages to the NMS when neighbor information changed. It is disabled by default. User Guide 366