TP-Link T1500-28PCT T1500-28PCTTL-SL2428PUN V3 User Guide - Page 480
Switch#con Switchconfig#interface gigabitEthernet, Switchconfig-if#qos queue, weight
View all TP-Link T1500-28PCT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 480 highlights
Configuring QoS Class of Service Configuration Step 3 Step 4 Step 5 Step 6 qos queue tc-queue mode {sp | wrr} [weight weight] Specify the type of scheduling used for corresponding queue. When the network congestion occurs, the egress queue will determine the forwarding sequence of the packets according to the type. By default, it is wrr mode and the all the queue weights are 1. tc-queue: Specify the ID number of TC queue. The valid values are from 0 to 7. sp: In sp mode, the egress queue will use SP (Strict Priority) to process the traffic in different queues. When congestion occurs, the traffic will be transmitted according to its queue priority strictly. The queue with higher priority occupies the whole bandwidth. Packets in the queue with lower priority are sent only when the queue with higher priority is empty. wrr: In wrr mode, the egress queue will use WRR (Weighted Round Robin) to process the traffic in different queues. When congestion occurs, all the traffic will be transmitted, but the bandwidth that each traffic queue occupies will be allocated based on the queue weight. weight: Specify the queue weight for the desired queue. This value can be set only in the wrr mode. The valid values are from 1 to 127. show qos queue interface [fastEthernet port | gigabitEthernet port | ten-gigabitEthernet port | port-channel port-channel-id] Verify the scheduler settings.. end Return to privileged EXEC mode. copy running-config startup-config Save the settings in the configuration file. Note: With ACL Redirect feature, the switch maps all the packets that meet the configured ACL rules to the new TC queue, regardless of the mapping relations configured in this section. The following example shows how to specify the scheduler settings for port 1/0/1. Set the scheduler mode of TC1 as sp mode, set the scheduler mode of TC4 as wrr mode and set the queue weight as 5. Switch#configure Switch(config)#interface gigabitEthernet 1/0/1 Switch(config-if)#qos queue 1 mode sp Switch(config-if)#qos queue 4 mode wrr weight 5 Switch(config-if)#show qos queue interface gigabitEthernet 1/0/1 Gi1/0/1----LAG: N/A Queue Schedule Mode Weight ----- TC0 WRR 1 User Guide 457