TP-Link T1500-28PCT T1500-28PCTTL-SL2428PUN V3 User Guide - Page 852

Configuring System Logs System Logs Configurations Step 2 Step 3 Step 4 Step 5 logging host index idx host-ip level Configure a remote host to receive the switch's system logs. The host is called Log Server. You can remotely monitor the settings and operation status of the switch through the log server. idx: Enter the index of the log server. The switch supports 4 log servers at most. host-ip: Enter the IP address of the log server. level: Specify the severity level of the log messages sent to the log server. The range is from 0 to 7, and a lower value indicates a higher severity. Only log messages with a severity level value that is the same or lower than this will be sent. The default is 6, indicating that the log information of levels 0 to 6 will be sent to the log server. show logging loghost [ index ] View the configuration information of the log server. index: Enter the index of the log server to view the corresponding configuration information. If no value is specified, information of all log hosts will be displayed. end Return to privileged EXEC mode. copy running-config startup-config Save the settings in the configuration file. The following example shows how to set the remote log on the switch. Enable log server 2, set its IP address as 192.168.0.148, and allow logs of levels 0 to 5 to be sent to the server: Switch#configure Switch(config)# logging host index 2 192.168.0.148 5 Switch(config)# show logging loghost Index Host-IP Severity Status 1 0.0.0.0 6 disable 2 192.168.0.148 5 enable 3 0.0.0.0 6 disable 4 0.0.0.0 6 disable Switch(config)#end Switch#copy running-config startup-config User Guide 829