TP-Link T1500-28PCT T1500-28PCTTL-SL2428PUN V3 User Guide - Page 805

 Notification Configurations Step 3 Step 4 end Return to Privileged EXEC Mode. copy running-config startup-config Save the settings in the configuration file. The following example shows how to configure the switch to enable IP-Change trap: Switch#configure Switch(config)#snmp-server traps ip change Switch(config)#end Switch#copy running-config startup-config ■■ Enabling the SNMP PoE Traps Globally Note: Only T1500-28PCT. TL-SG2210MP and TL-SG2210P support PoE traps. Step 1 Step 2 Step 3 configure Enter Global Configuration Mode. snmp-server traps power [over-max-pwr-budget | port-pwr-change | port-pwr-deny | portpwr-over-30w | port-pwr-overload | port-short-circuit | thermal-shutdown ] Enable the PoE traps. The command without any parameter enables all PoE traps. By default, all PoE traps are disabled. over-max-pwr-budget: Triggered when the total power required by the connected PDs exceeds the maximum power the PoE switch can supply. port-pwr-change: Triggered when the total power required by the connected PDs exceeds the maximum power the PoE switch can supply. port-pwr-deny: Triggered when the switch powers off PDs on low-priority PoE ports. The switch powers off them to ensure stable running of the other PDs when the total power required by the connected PDs exceeds the system power limit. port-pwr-over-30w: Triggered when the power required by the connected PD exceeds 30 watts. port-pwr-overload: Triggered when the power required by the connected PD exceeds the maximum power the port can supply. port-short-circuit: Triggered when a short circuit is detected on a port. thermal-shutdown: Triggered when the PSE chip overheats. The switch will stop supplying power in this case. end Return to Privileged EXEC Mode. User Guide 782