TP-Link T1500-28PCT T1500-28PCTTL-SL2428PUN V3 User Guide - Page 847

Configuring System Logs System Logs Configurations 2.1 Using the GUI 2.1.1 Configuring the Local Logs Choose the menu MAINTENANCE > Logs > Local Logs to load the following page. Figure 2-1 Configuring the Local Logs Follow these steps to configure the local logs: 1) Select your desired channel and configure the corresponding severity and status. Channel Severity Status Sync-Periodic 2) Click Apply. Local logs includes 2 channels: log buffer and log file. Log buffer indicates the RAM for saving system logs. The channel is enabled by default. Information in the log buffer is displayed on the MAINTENANCE > Logs > Logs Table page. It will be lost when the switch is restarted. Log file indicates the flash sector for saving system logs. Information in the log file will not be lost after the switch is restarted and can be exported on the MAINTENANCE > Logs > Back Up Logs page. Specify the severity level of the log messages that are saved to the selected channel. Only log messages with a severity level value that is the same or lower than this will be saved. There are eight severity levels marked from 0 to 7. A lower value indicates a higher severity. Enable or disable the channel. By default, the log information is saved in the log buffer immediately, and synchronized to the log file every 24 hours. If necessary, you can modify the log synchronization frequency using the CLI. 2.1.2 Configuring the Remote Logs You can configure up to four hosts to receive the switch's system logs. These hosts are called Log Servers. The switch will forward the log message to the servers once a log User Guide 824