TRENDnet TFM-560E Manual - Page 46

@ Wait for 5 seconds of silence after dialing number ; Return to command state after dialing a number without disconnecting the call En AT command echo options E0 Echo disabled E1 * Echo enabled Hn Switch-hook control H0 * Modem goes on-hook H1 Modem goes off-hook Mn Speaker control M0 Speaker always off M1 * Speaker on until carrier present M2 Speaker always on M3 Speaker off during dialing and on until carrier present Nn Select negotiate handshake N0 When originating or answering, handshake only at the communication rate specified by S37 register and "ATBn" and no fallback N1 * When originating or answering, start handshaking only at the communication standard specified by S37 register and "ATBn" During handshake, fallback to a lower speed may occur. On Go on-line O0 Return modem to a previously established state (return to data mode). O1 Begin a retrain sequence, then return to on- line state. O3 Issue a rate re-negotiation, then return to on-line state. P Enable pulse dialing Qn Result code display options Q0 * Result code enabled Q1 Result code disabled T Enable tone dialing Vn Result code form V0 Display result code in numeric form (see also the result code options table) V1 * Display result code in verbose (text) form Wn Select extended result code options W0 CONNECT result code reports DTE speed. Disable protocol result codes. (see also the "Result Code Options Table") W1 CONNECT result code reports DTE speed. - 43 -