TRENDnet TFM-560E Manual - Page 52

APPENDIX B: S-REGISTERS S-Registers, "ATSn=x" Regist er S0= S1= S2= S3= S4= S5= S6= S7= Dec. Function & Description Default 0 - 255 0 - 255 0 - 255 0 - 127 0 - 127 0 - 32, 127 2 - 65 Set the number of the rings required 000 before the modem automatically answers a call. Set "S0=0" to disable auto- answer mode Count the incoming rings and store the 000 value to this register. The value of this register is incremented with each ring. If no rings occur over an 8 sec. interval, this register is cleared. User can read but should not change this value S2 holds the decimal value of the ASCII 043 character used as the escape character. The default value (043) corresponds to an ASCII character "+". A value of 128 to 255 disables the escape process, i.e., no escape character will be recognized Hold the decimal value of the Carriage 013 Return character used as the command line and result code terminator. Pertain to asynchronous operation only Hold the decimal value of the character 010 recognized as a line feed.The line feed control character is output after the carriage return control character if verbose result code are used. Hold the decimal value of the character 008 recognized as a backspace. The modem will not recognize the backspace character if this register is set to a value greater than 32 Set the length of time, in seconds, that the modem must wait (minimum 2 seconds even if the value is less than 2) after going off-hook before dialing the first digit of the telephone number For international version 003 Set the time, in seconds, that the modem must wait before hanging up because carrier is not detected - 49 -