Texas Instruments TINSPIRE Getting Started - Page 16
Checking the access point LEDS, Starting the wizard, POWER, STATUS: 100 LINK/ACT, SIGNAL: 802.11 b/g - nspire computer link software
View all Texas Instruments TINSPIRE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Checking the access point LEDS Status Power Test Signal POWER - Indicates that the access point is receiving power from the power adapter. TEST - The access point is in self-test mode. This LED should blink for a minute and then stop. STATUS: 100 LINK/ACT - Indicates data transfer. SIGNAL: 802.11 b/g - Indicates wireless link activity. Starting the wizard When you complete the installation of the TI-Nspire™ Navigator™ Teacher Software, open TI-Nspire™ Network Manager to set up your system. ` To open Network Manager, click Tools > Network Manager. A setup wizard helps you through the next steps. Note: You can run the setup wizard later by opening TI-Nspire™ Network Manager and clicking Actions > Network Setup Wizard. 1. Confirm that the AC9930 power adapter is connected to the access point. 2. Plug the AC adapter into a power outlet. 3. Plug the USB cable into the computer. 4. Click Next to proceed with the wizard. TI-Nspire™ Network Manager displays a dialog box to select a country and channel. 10 Setting up the TI-Nspire™ Navigator™ Teacher Software