Toshiba MW24FM3 Owners Manual - Page 4

registers, stoves

Get Toshiba MW24FM3 PDF manuals and user guides View all Toshiba MW24FM3 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 4 highlights

Introduction IMPORTANT SAFEGUARDS 14. POWER LINES An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall onto or against such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits, as contact with them might be fatal. 15. OVERLOADING Do not overload wall outlets and extension cords, as this can result in a risk of fire or electric shock. 16. OBJECT AND LIQUID ENTRY Do not push objects through any openings in this unit, as they may touch dangerous voltage points or short out parts that could result in fire or electric shock. Never spill or spray any type of liquid into the unit. 17. OUTDOOR ANTENNA GROUNDING If an outside antenna or cable system is connected to the unit, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges, Section 810 of the National Electrical Code (NEC), ANSI/NFPA 70, provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. 18. SERVICING Do not attempt to service this unit yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel. For example: a. When the power-supply cord or plug is damaged. b. If liquid has been spilled, or objects have fallen into the unit. c. If the unit has been exposed to rain or water. d. If the unit does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions, as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the unit to its normal operation. e. If the unit has been dropped or the cabinet has been damaged. f. When the unit exhibits a distinct change in performance, this indicates a need for service. 19. REPLACEMENT PARTS When replacement parts are required, be sure the service technician uses replacement parts specified by the manufacturer or those that have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock or other hazards. 20. SAFETY CHECK Upon completion of any service or repairs to this unit, ask the service technician to perform safety checks to determine that the unit is in proper operating condition. 21. WALL OR CEILING MOUNTING The product should be mounted to a wall or ceiling only as recommended by the manufacturer. 22. HEAT The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat. 23. DISC TRAY Keep your fingers well clear of the disc tray as it is closing. It may cause serious personal injury. 24. CONNECTING When you connect the product to other equipment, turn off the power and unplug all of the equipment from the wall outlet. Failure to do so may cause an electric shock and serious personal injury. Read the owner's manual of the other equipment carefully and follow the instructions when making any connections. 25. LASER BEAM Do not look into the opening of the disc tray or ventilation opening of the product to see the source of the laser beam. It may cause sight damage. 26. DISC Do not use a cracked, deformed, or repaired disc. These discs are easily broken and may cause serious personal injury and product malfunction. 4

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
Introduction
IMPORTANT
SAFEGUARDS
14.
POWER
LINES
An
outside
antenna
system
should
not
be
located
in
the
vicinity
of
overhead
power
lines
or
other
electric
light
or
power
circuits,
or
where
it
can
fall
onto
or
against
such
power
lines
or
circuits.
When
installing
an
outside
antenna
system,
extreme
care
should
be
taken
to
keep
from
touching
such
power
lines
or
circuits,
as
contact
with
them
might
be
fatal.
15.
OVERLOADING
Do
not
overload
wall
outlets
and
extension
cords,
as
this
can
result
in
a
risk
of
fire
or
electric
shock.
16.
OBJECT
AND
LIQUID
ENTRY
Do
not
push
objects
through
any
openings
in
this
unit,
as
they
may
touch
dangerous
voltage
points
or
short
out parts
that
could
result
in
fire
or
electric
shock.
Never
spill
or
spray
any
type
of
liquid
into
the
unit.
17.
OUTDOOR
ANTENNA
GROUNDING
If
an
outside
antenna
or
cable
system
is
connected
to
the
unit,
be
sure
the
antenna
or
cable
system
is
grounded
so
as
to
provide
some
protection
against
voltage
surges
and
built-up
static
charges,
Section
810
of
the
National
Electrical
Code
(NEC),
ANSI/NFPA
70,
provides
information
with
respect
to
proper
grounding
of
the
mast
and
supporting
structure,
grounding
of
the
lead-in
wire
to
an
antenna
discharge
unit,
size
of
grounding
conductors,
location
of
antenna
discharge
unit,
connection
to
grounding
electrodes,
and
requirements
for
the
grounding
electrode.
18.
SERVICING
Do
not
attempt
to
service
this
unit
yourself
as
opening
or
removing
covers
may
expose
you
to
dangerous
voltage
or
other
hazards.
Refer
all
servicing
to
qualified
service
personnel.
For
example:
a.
When
the
power
-supply
cord
or
plug
is
damaged.
b.
If
liquid
has
been
spilled,
or
objects
have
fallen
into
the
unit.
c.
If
the
unit
has
been
exposed
to
rain
or
water.
d.
If
the
unit
does
not
operate
normally
by
following
the
operating instructions.
Adjust
only
those
controls
that
are
covered
by
the
operating
instructions,
as
an
improper
adjustment
of
other
controls
may
result
in
damage
and
will
often
require
extensive
work
by
a
qualified
technician
to
restore
the
unit
to
its
normal
operation.
e.
If
the
unit
has
been
dropped
or
the
cabinet
has
been
damaged.
f.
When
the
unit
exhibits
a
distinct
change
in
performance,
this
indicates
a
need
for
service.
19.
REPLACEMENT
PARTS
When
replacement
parts
are
required,
be
sure
the
service
technician
uses
replacement
parts
specified
by
the
manufacturer
or
those
that
have
the
same
characteristics
as
the
original
part.
Unauthorized
substitutions
may
result
in
fire,
electric
shock
or
other
hazards.
20.
SAFETY
CHECK
Upon
completion
of
any
service
or
repairs
to
this
unit,
ask
the
service
technician
to
perform
safety
checks
to
determine
that
the
unit
is
in
proper
operating
condition.
21.
WALL
OR
CEILING
MOUNTING
The
product
should
be
mounted
to
a
wall
or
ceiling
only
as
recommended
by
the
manufacturer.
22.
HEAT
The
product
should
be
situated
away
from
heat
sources
such
as
radiators,
heat
registers, stoves,
or
other
products
(including
amplifiers)
that
produce
heat.
23.
DISC
TRAY
Keep
your
fingers
well
clear
of
the
disc
tray
as
it is
closing.
It
may
cause
serious
personal
injury.
24.
CONNECTING
When
you
connect
the
product
to
other
equipment,
turn
off
the
power
and
unplug
all
of
the
equipment
from
the
wall
outlet.
Failure
to
do
so
may
cause
an
electric
shock
and
serious
personal
injury.
Read
the
owner's
manual
of
the
other
equipment
carefully
and
follow
the
instructions
when
making
any
connections.
25.
LASER
BEAM
Do
not
look
into
the
opening
of
the
disc
tray
or
ventilation
opening
of
the
product
to
see
the
source
of
the
laser
beam.
It
may
cause
sight
damage.
26.
DISC
Do
not
use
a
cracked,
deformed,
or
repaired
disc.
These
discs
are
easily
broken
and
may
cause
serious
personal
injury
and
product
malfunction.
4