Toshiba TDP-P75 User Manual - Page 41

English Troubleshooting Problem The projector does not turn on. No picture. Image is unstable. Picture is blurred. Remote control does not work correctly Cause Remedy There is no power from the power cord. Plug the power cord into the AC inlet on the projector, and plug the power cord into to a power outlet. If the power outlet has a switch, make sure it is switched on. p. 26 Attempting to turn the projector on Wait until the cooling-down process is again during the cooling process. completed. The lamp cover is not securely attached. Correctly attach the lamp cover. Turn the video source on and check that The video source is not turned on the signal cable is connected correctly. or connected correctly. p. 23 The projector is not correctly connected to the input source device. Check the connection. p. 23 The input signal has not been correctly selected. Select the correct input signal with the INPUT buttons on the remote control or INPUT on the projector. p. 28 The connection cables are not securely connected to the projector or the signal source. Correctly connect the cables to the appropriate terminals. The projection lens is not correctly focused. Adjust the focus of the lens using the focus ring. p. 27 The projector and the screen are not aligned properly. Adjust the projection angle and direction as well as the height of this unit if necessary. p. 27 The lens cap is still attached to the lens Remove the lens cap. The batteries are out of power. Replace both of the batteries with new ones. p. 19 There is an obstacle between the remote control and the projector. Remove the obstacle. You are too far away from the projector. Stand within 5 meters (16.4 feet) of the projector. p. 19 Troubleshooting 41