Tripp Lite 9PX11K Eaton 9PX 8000 9PX 11000 9PX EBM 240V Installation and User - Page 20

Rack installation

Get Tripp Lite 9PX11K PDF manuals and user guides View all Tripp Lite 9PX11K manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

3. Installation 3.7 Rack installation If you ordered other UPS accessories, refer to specific user manuals to check the rack installation with the UPS. • Prepare EBM for rack mounting This step requires two people. The Extended Battery Module is very heavy. To ease its rack mounting, you can remove the battery pack from the EBM as explained below. 1. Remove the center cover of the front panel. 2. Remove the four screws to open the front panel. 3. Remove the three screws to pull out the metal protection cover of the battery. 4. Pull out the plastic handle of the left and right battery packs, and slide the packs out slowly on to a flat and stable surface. Use two hands to support the battery packs. Set them aside for reinstalling after that the EBM is rack mounted. 5. Mount the EBM on rack. 6. Put back the battery packs, screw back the metal protection cover and the front panel, then clip the center cover. Page 20 8-11kVA US_EN

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
Page 20
8-11kVA US_EN
3.7
Rack installation
If you ordered other UPS accessories, refer to specific user manuals to check the rack installation
with the UPS.
•
Prepare EBM for rack mounting
This step requires two people.
The Extended Battery Module is very heavy. To ease its rack mounting, you can remove the battery pack
from the EBM as explained below.
1.
Remove the center cover of the front panel.
2.
Remove the four screws to open the front panel.
3.
Remove the three screws to pull out the metal protection cover of the battery.
4.
Pull out the plastic handle of the left and right battery packs, and slide the packs out slowly on to a flat
and stable surface. Use two hands to support the battery packs. Set them aside for reinstalling after that
the EBM is rack mounted.
5.
Mount the EBM on rack.
6.
Put back the battery packs, screw back the metal protection cover and the front panel,
then clip the center cover.
3. Installation