Tripp Lite 9PX11K Eaton 9PX 8000 9PX 11000 9PX EBM 240V Installation and User - Page 25

ENGLISH 4. Power cables connection 4.1 Access to terminal blocks 1. Remove the terminal blocks cover (one screw) 2. Punch the knockouts and insert the cables/conduits inside • High leakage current: Earth connection essential before connecting supply. 4.2 Common input sources connection This type of connection must be carried out by qualified electrical personnel Before carrying out any connection, check that the upstream protection devices (Normal AC source and Bypass AC source) are open "O" (Off). Always connect the ground wire first If you ordered a HotSwap MBP, refer to the specific user manual to check the terminal blocks connection of the UPS with the MBP. BYPASS AC SOURCE N(L2) t L1 N(L2) t OUTPUT NORMAL AC SOURCE t N(L2) L1 L1 L1 1. Make sure the jumper is connected 2. Insert the Normal AC cable through the cable gland 3. C onnect the three cables to the Normal AC source terminal blocks 4. Insert the Output cable through the cable gland 5. C onnect the three cables to the Output terminal blocks 6. P ut back and secure the terminal blocks cover with the screw 7. - Tighten the cable glands. 8-11kVA US_EN Page 25