Troy-Bilt Pro-Line CRT Service Manual - Page 29
ID PVC Pipe for Bushing Installation
View all Troy-Bilt Pro-Line CRT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Troy-Bilt Small Frame Tillers 8.31. If the drive shaft assembly end play is not within tolerance, .005" to .015", perform the above procedures again. 8.32. If the drive shaft assembly is within .005" to .015", continue through this section. See Figure 8.32. 8.34. Drive one of the wheel shaft's bronze bushings into the transmission housing until it is flush with the inside of the housing using a bushing driver and hammer. See Figure 8.34. Bronze Bushing Flush Drive Shaft Assembly End Play Tolerance - .005" to .015" Figure 8.32 8.33. Remove the drive shaft assembly and all components. See Figure 8.33. All Drive Shaft Assembly Components Removed Figure 8.34 NOTE: A 1" I.D. PVC pipe by 7" long works well as a bushing installation tool. See Image Below. 1" ID PVC Pipe Hex Flange Screws Drive Shaft Assembly Snap Ring Support Washer 7" Long Rear Tapered Roller Bearing Race Rear Bearing Cap Shims Rear Bearing Cap Race Short Hex Screw Front Tapered Roller Bearing Figure 8.33 1" ID PVC Pipe for Bushing Installation 25