Viking VUWC Installation Instructions - Page 11

Operating Instructions Interior Adjustments All 5 Series models feature side mounted rack supports with 19 adjustment positions. All wine cellars ship with 7 racks designed to hold the maximum number of typical white and red wine bottles. Remove and reposition as desired to accommodate a variety of bottle sizes and shapes WINE RACK ADJUSTMENT Wine Rack Removal 1. Fully extend empty rack 5. Once removed, retract the slides. Note: The slides on the rack have a thin coating which is used to block moisture and provide lubrication. Use care when handling. Wine Rack Installation 1. Insert empty rack into unit with one side tilted slightly downward until back pin is between front and rear rail supports. 2. Firmly grasp both sides of rack and lift front end of rack slightly (about ¼") to center the pin in the slot 2. Tilt rack back to horizontal and line up 2 back pins with back slots. Center the pins Front Pin Back Pin Center the pin 3. Pull rack towards you until all pins are clear of the slots. If only repositioning the rack, do not remove completely - go to "Rack Installation" Step 2. 4. Slightly tilt one side. Gently pull rack towards you to remove rack from unit. 3. Line up 2 back pins with 2 back slots and 2 front pins with 2 front slots. 4. Continue inserting rack until all four pins are fully inserted. Front of rack will set down slightly into the front slots and be locked into position. Note: Take care when removing rack to avoid scratching interior of unit. 11