Viking VUWC Installation Instructions - Page 8
Caution
View all Viking VUWC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Installation Door Adjustments DOOR ALIGNMENT AND ADJUSTMENT Align and adjust the door if it is not level or not sealing properly. If the door is not sealed, the unit may not cool properly, or excessive frost or condensation may form in the interior. NOTICE Properly aligned, the door's gasket should be firmly in contact with the cabinet all the way around the door (no gaps). Carefully examine the door's gasket to ensure that it is firmly in contact with the cabinet. Also make sure the door gasket is not pinched on the hinge side of the door. ! CAUTION Do not attempt to use the door to raise or pivot your unit. This would put excessive stress on the hinge system. Alignment and Adjustment Procedure 1. Open door and remove gasket near the hinges. 2. Using a T-25 Torx bit, loosen each pair of Torx head screws both the upper and lower hinge plates. 3. Square and align door as necessary. 4. Tighten Torx head screws on hinge. 5. Reinstall gasket into the channel starting at the corner. T-25 Torx Screw REVERSING THE DOOR 1. Open door. 2. Using T-25 Torx bit loosen screw #1 and remove screw #2 on top and bottom hinge. Slide and remove the door from the unit. 2 1 Note: One hinge includes a metal spacer. Spacer must be used with that hinge when reversing the door. 3. Remove caps from screw heads on opposite side (2 on top and 2 on bottom). Using #2 Phillips bit, remove the 4 underlying screws. Reinstall the screws and caps on the opposite side. 4. Partially install screw #1 in the outer most holes on top and bottom. Rotate door 180o, align hinge over screw #1 and slide/seat into position. Reinstall screw #2 on top and bottom. Tighten both screws and install hinge cover. Align and adjust the door: Align and adjust the door (see DOOR ALIGNMENT AND ADJUSTMENT). T-25 Torx Screw 8