Weider Pro 9645 English Manual - Page 14
Low Pulley
View all Weider Pro 9645 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
27. Locate the Low Cable (23). Route the Low 27 Cable under the 3 1/2" Low Pulley (102). Be sure that the end of the Cable with the ball is on the indicated side of the Press Frame (17) and that the Cable is between the Pulley and the crossbar on the Press Frame. Tighten the 3/8" Nylon Locknut (21) and the 3/8" x 3 3/4" Bolt (not shown). 1) 0 t ® 6 Crossbar 21 102 23 Ball 17 28. Route the Low Cable (23) around the 3 1/2" Pulley (15) attached to the lower hole in the 28 Front Upright (42). See the inset drawing. Be sure that the Cable Trap (66) is turned to hold the Cable in place and that the Cable is routed around the Pulley as shown. Tighten the 3/8" Nylon Locknut (21) and the 3/8" x 3 3/4" Bolt (88). 42 15 23 15 88 I 66 427 Inset shows view from other side 23 29. Route the Low Cable (23) around the 3 1/2" Pulley (15) attached to the upper hole in the 29 Press Frame (17). Be sure that the Cable Trap (66) is turned to hold the Cable in place and that the Cable is routed around the Pulley as shown. Tighten the 3/8" Nylon Locknut (21) and the 3/8" x 3 1/2" Bolt (not shown). 51 . 23 /® 15 ® 21 66 17 30. Route the Low Cable (23) around the 3 1/2" Pulley (15) attached to the upper hole in the 30 Front Upright (42). See the inset drawing. 23 Be sure that the Cable Trap (66) is turned to hold the Cable in place and that the ,___, 0 15 42 Cable is routed around the Pulley as / 0/® shown. Tighten the 3/8" Nylon Locknut (21) and the 3/8" x 3 3/4" Bolt (88). ..--. 23 15 88 66 42 Inset shows view from other side 14