Weider Pro 9645 English Manual - Page 4
Assembly
View all Weider Pro 9645 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
ASSEMBLY Before beginning assembly, carefully read the following information and instructions: • Place all parts of the PRO 9645 in a cleared area and remove the packing materials; do not dispose of the packing materials until assembly is completed. • The assembly is broken into four stages: 1) frame assembly, 2) arm assembly, 3) cable and pulley assembly, and 4) seat and backrest assembly. The hardware for each stage is packaged separately. • Wait until you begin each assembly stage to open the parts bag labeled for that assembly stage. • For help identifying the small parts used in assembly, use the PART IDENTIFICATION CHART located in the center of this manual. Note: Some small parts may have been preattached for shipping. If a part is not in the parts bag, check to see if it has been pre-attached. • As you assemble the PRO 9645 be sure that all parts are oriented as shown in the drawings. • Tighten all parts as you assemble them, unless instructed to do otherwise. THE FOLLOWING TOOLS (NOT INCLUDED) ARE REQUIRED FOR ASSEMBLY: • Two (2) adjustable wrenches :=Lo • One (1) standard screwdriver '1=2 1:1=1 • One (1) phillips screwdriver • One (1) rubber mallet • Lubricant, such as grease or petroleum jelly, and soapy water will also be needed. Assembly will be more convenient if you have the following tools: A socket set, a set of open-end or closed-end wrenches, or a set of ratchet wrenches. . Before beginning assembly, be sure that you have read and understand the infor- 1 mation in the box above. Locate and open the parts bag labeled "FRAME ASSEMBLY." Press two 2" Square Outer Caps (51) onto the Stabilizer (5). Press a 2" Square Inner Cap (27) into the Base (4). co Insert six 5/16" x 2 1/2" Carriage Bolts (1) up 51 through the Stabilizer (5). Insert two 5/16" x 2 1/2" Carriage Bolts up through the Base (4). LLJ Attach the Base (4) to the Stabilizer (5) with two 5/16" x 2 3/4" Bolts (11), two 5/16" Flat Washers (8), and two 5/16" Nylon Locknuts (3). Do not tighten the Nylon Locknuts yet. 51 11 8 1 3 4 5 1 27 4