Weider Pro 9645 English Manual - Page 17
inserted, shown., Pulley, shown, Cable, positioned, place., inside, Bracket., assembled., groove,
View all Weider Pro 9645 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
36. Slide a 5/16" Flat Washer (8) onto a 5/16" x 2 3/4" Bolt (11). Insert the Bolt through the indicated hole in the Pivot Arm (101). The Bolt must be inserted from the side shown. Fully tighten a 5/16" Nylon Jam Nut (93) onto the Bolt. Wrap the Military Press Cable (72) around a 3 1/2" Pulley (15). Attach the Pulley and a Cable Trap (66) to the Pivot Arm (101) with the 3/8" x 3 3/4" Bolt (88), a 3/8" Flat Washer (9), and a 3/8" Nylon Locknut (21). Be sure that the Pulley is on the side shown and that the Cable Trap is positioned to hold the Cable in place. 36 21 93 9 '• 101 72 15 11 66 88 a 0 a 37. See inset drawing A. Attach a 3 1/2" Pulley (15) and a Cable Trap (66) to the upper hole in a Long "U"-Bracket (57) with a 3/8" x 2" Bolt (12) and a 3/8" Nylon Locknut (21). Be sure that the Cable Trap is inside the Long "U"-Bracket. (Note: This may come preassembled.) Route the Military Press Cable (72) through the Long "U"-Bracket (57) and the 3 1/2" Pulley (15). Be sure that the Cable is in the groove of the Pulley and that the Cable and Pulley move smoothly. See inset drawing B. Slide the end of the Military Press Cable (72) onto the end of the 5/16" x 2 3/4 Bolt (11). Thread another 5/16" Nylon Jam Nut (93) onto the Bolt. Do not fully tighten the second Jam Nut. There must be room between the two Jam Nuts for the end of the Cable to pivot. 37 15 57 72 15 A 21 66 a 57 12 93 72 11 17