Weider Weevsy3426 Uk Manual - Page 13

10. Apply grease to an M10 x 90mm Bolt (67). Attach the Pivot Frame (5) to the Top Frame (4) with the Button Bolt and an M10 Locknut (56). Do not overtighten the Locknut; the Pivot Frame must pivot freely. Attach the two Arm Pins (40) to the Pivot Frame (5) with two M4 x 19mm Screws (69). Insert the Arm Pins into the two holes in the Upright (3). 10 56 69 5 40 4 67 Holes Grease 3 69 40 11. Apply grease to an M10 x 55mm Bolt (66). Attach a Cable Pivot (39) to the Right Arm (9) with the Button Bolt and an M10 Locknut (56). Do not overtighten the Locknut; the Cable Pivot must pivot freely. Wet the inside of a Large Foam Pad (42) with soapy water. Slide the Large Foam Pad onto the Right Arm (9). Attach the upper end of a Handle (11) to the Right Arm (9) with an M10 x 75mm Bolt (85), two M10 Washers (57), two 16mm Spacers (52), and an M10 Locknut (56). Do not tighten the Button Bolt yet. Press a Handle Cap (31) into the Right Arm (9). Attach the lower end of the Handle (11) to the Right Arm with an M10 x 40mm Bolt (77) and an M10 Large Washer (80). Tighten the M10 x 75mm Bolt (85). Assemble the Left Arm (10) in the same manner. 11 52 57 57 56 66 Grease 9 52 39 85 56 10 11 42 80 31 77 13