Yamaha CL3 Cl Stagemix V3.0 User Guide - Page 16

When a Stereo Mix Bus is active as the Target Mix Bus, a Pan slider

Get Yamaha CL3 PDF manuals and user guides View all Yamaha CL3 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 16 highlights

Yamaha Commercial Audio CL StageMix V3.0 User Guide Choose the "Target Mix Bus" from Mix 1-24 and Matrix 1-8. The currently selected Mix will appear as a white button with a check mark. Stereo pairs appear as single large buttons. When a Mix, Matrix or Master block is selected in the "Navigation/Meter Bridge", the [SENDS ON FADERS] button is not available. 4.9.1 Mix Send Levels When in "SENDS ON FADERS" mode, the fader in each channel strip controls the level being sent from that channel to the currently selected Mix Bus. Note: if a Mix Bus is set to "Fixed" mode, send levels to that Mix Bus are fixed at 0dB and cannot be adjusted. Mix Send faders will not appear when a Mix Bus set to "Fixed" mode is selected. 4.9.2 Mix Sends ON In "SENDS ON FADERS" mode, the [ON] button in each channel strip is used to turn On/Off the Mix Send from each channel to the currently selected target Mix bus. 4.9.3 Stereo Mix Pan When a Stereo Mix Bus is active as the "Target Mix Bus", a Pan slider will be available at the top of each channel strip in "SENDS ON FADERS" mode. Adjusting this slider will change the Pan position for that channel's send to the currently active Stereo Mix Bus. The Pan position's numerical value appears above the slider. Page 16

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
Yamaha Commercial Audio
CL StageMix V3.0 User Guide
Choose the “Target Mix Bus” from Mix 1-24 and Matrix 1-8.
The currently
selected Mix will appear as a white button with a check mark.
Stereo pairs
appear as single large buttons.
When a Mix, Matrix or Master block is selected in the “Navigation/Meter
Bridge”, the [SENDS ON FADERS] button is not available.
4.9.1
Mix Send Levels
When in “SENDS ON FADERS” mode, the fader in each channel strip
controls the level being sent from that channel to the currently selected
Mix Bus.
Note: if a Mix Bus is set to “Fixed” mode, send levels to that Mix Bus
are fixed at 0dB and cannot be adjusted.
Mix Send faders will not
appear when a Mix Bus set to “Fixed” mode is selected.
4.9.2 Mix Sends ON
In “SENDS ON FADERS” mode, the [ON] button in each channel strip
is used to turn On/Off the Mix Send from each channel to the currently
selected target Mix bus.
4.9.3 Stereo Mix Pan
When a Stereo Mix Bus is active as the “Target Mix Bus”, a Pan slider
will be available at the top of each channel strip in “SENDS ON
FADERS” mode.
Adjusting this slider will change the Pan position for
that channel’s send to the currently active Stereo Mix Bus.
The Pan
position’s numerical value appears above the slider.
Page 16