Yamaha MX61 Reference Manual - Page 65

Performance Song/Pattern File Utility Remote Parameter Description KnobFuncDispSw (Knob Function display switch) Determines whether the Knob Function display (which shows the functions of Knobs [A] - [D] and their settings) is called up or not when pressing the [KNOB FUNCTION] button. Settings: Settings: off, on *Cut**Rez**Cho**Rev (+34)*:+00***40***12 Knob Function display appears when pressing [KNOB FUNCTION]. Utility General MIDI Controllers Remote Utility Job QuickSeup Factory Set Version KnobDispTime (Knob Function display switch) Determines whether or not the Knob Function display appears when operating the Knobs, and how long the display will continue to be shown. Settings: off, 1 sec, 1.5 sec, 2 sec, 3 sec, 4 sec, 5 sec, keep off When this selected, the display is not called up even if you operate the Knobs. 1 sec - 5 sec.... Turning one of the Knobs will cause the display to appear after an elapsed time of between 1 - 5 seconds, and then automatically close. keep Operating the Knob will cause the popup to be shown continuously until you press a button. q**Common*Cutoff***w e*******(+15)******r Knob Function display appears when operating the Knobs. StartUp AutoOff (Auto Power Off time) Determines the default power-on Performance-letting you select which Performance is automatically called up when you turn the power on. Settings: 1 -128 Determines the amount of time that elapses before the power is automatically turned off if the instrument is not operated for a specified period of time. Default setting is "30min." Settings: off (Disables Auto Power Off), 5min, 10min, 15min, 30min, 60min, 120min (minutes) NOTE You can set this parameter to "off" by holding down the lowest key on the keyboard and turning the power on. This operation retains the "off" setting even if the power is turned off. MIDI Parameter MIDI IN/OUT LocalCtrl (Local Control switch) BankSel (Bank Select) PgmChange (Program Change) Description Determines which physical output/input terminal(s) will be used for transmitting/receiving MIDI data. Settings: MIDI, USB NOTE The two types of terminals above cannot be used at the same time. Only one of them can be used to transmit/receive MIDI data at a time. Determines whether or not the tone generator of the instrument responds to your keyboard playing. Normally, this should be set to "on"-since you'll want to hear the sound of the MX49/MX61 as you play it. Even if this is set to "off," the data will be transmitted via MIDI. Also, the internal tone generator block will respond to messages received via MIDI. Settings: off (disconnect), on (connect) Determines whether or not this instrument enables Bank Select messages to be both transmitted and received. When this is set to "on," this synthesizer responds to incoming Bank Select messages, and it also transmits appropriate Bank Select messages (when using the panel). Settings: off, on Determines whether or not this instrument enables Program Change messages to be both transmitted and received. When this is set to "on," this synthesizer responds to incoming Program Change messages, and it also transmits appropriate Program Change messages (when using the panel). Settings: off, on MX49/MX61 Reference Manual 65