Yamaha RX-V363 Owner's Manual - Page 60
Problem, Cause, Remedy, Dolby Digital or DTS - power problem
UPC - 027108929781
View all Yamaha RX-V363 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
Troubleshooting Problem Cause Remedy Only the center speaker outputs substantial sound. When playing a monaural source with a CINEMA DSP program, the source signal is directed to the center channel, and the front and surround speakers output effect sounds. No sound is heard from the center speaker. "CENTER" in "SPEAKER SET" is set to Set "CENTER" to "SML" or "LRG". "NONE". Some sound field programs do not output Try another sound field program. sounds from the center speaker. No sound is heard from the surround speakers. "SUR. LR" in "SPEAKER SET" is set to "NONE". This unit is in the "STRAIGHT" mode and a monaural source is being played back. Set "SUR. LR" to "SML" or "LRG". Press LSTRAIGHT on the front panel so that "STRAIGHT" disappears from the front panel display. No sound is heard from the subwoofer. "BASS OUT" in "SPEAKER SET" is set to "FRNT" when a Dolby Digital or DTS signal is being played. Set "BASS OUT" to "SWFR" or "BOTH". "BASS OUT" in "SPEAKER SET" is set to "SWFR" or "FRNT" when a 2-channel source is being played. Set "BASS OUT" to "BOTH". The source does not contain low-frequency bass signals. Dolby Digital or DTS sources cannot be played. (Dolby Digital or DTS indicator in the front panel display does not light up.) The connected component is not set to output Dolby Digital or DTS digital signals. Audio input jack select is set to "ANALOG". Make an appropriate setting following the operating instructions for your component. Set Audio input jack select to "AUTO". A humming sound is Incorrect cable connections. heard. Connect the audio cables firmly. If the problem persists, the cables may be defective. The volume level cannot be increased, or the sound is distorted. You are attempting to set the volume level Adjust "MAX VOL." setting. higher than the maximum volume level. The component connected to the AUDIO OUT (REC) jacks on this unit is turned off. Turn on the power of the component. The sound effect cannot be recorded. It is not possible to record the sound effect with a recording component. A source cannot be recorded by an analog component connected to the AUDIO OUT (REC) jacks. The source component is not connected to Connect the source component to the analog AUDIO the analog AUDIO IN jacks on this unit. IN jacks. The sound field parameters and some other settings of this unit cannot be changed. "MEM.GUARD" in "OPTION MENU" is set to "ON". Set "MEM.GUARD" to "OFF". This unit does not operate properly. The internal microcomputer has been frozen by an external electric shock (such as lightning or excessive static electricity) or by a power supply with low voltage. Disconnect the power cable from the AC wall outlet and then plug it in again after about 30 seconds. "CHECK SP WIRES" appears in the front panel display. Speaker cables are short-circuited. Make sure all speaker cables are connected correctly. See page 45 34 45 36 46 46 - 31 - 48 - 15, 17 50 - 11 56 En