Yamaha RX-V373BL User Manual - Page 31

1 2 3 4 5 6 7 8 9 Automatic speaker setup Error messages If any error message is displayed during the measurement, resolve the problem and perform YPAO again. Auto Setup Start Exit ERROR E-5:Noisy PROCEED 5% Error message TV screen E-5:NOISY VOL. SW L CR SL SR Front display ■ Procedure to handle errors 1 Check the content of error message and press ENTER. 2 Use the cursor keys (e/r) to select the desired operation. To exit the YPAO measurement: a Select "EXIT" and press ENTER. b Use the cursor keys (q/w) to select "Exit" and press ENTER. c Disconnect the YPAO microphone from the unit. To retry the YPAO measurement from beginning: Select "RETRY" and press ENTER. To proceed with the current YPAO measurement (for E-5 and E-9 only): Select "PROCEED" and press ENTER. Error message E-1:No Front SP (E-1:NO FRNT SP) E-2:No Sur. SP (E-2:NO SUR SP) E-5:Noisy (E-5:NOISY) E-7:No MIC (E-7:NO MIC) E-8:No Signal (E-8:NO SIGNAL) E-9:User Cancel (E-9:CANCEL) E-10:Internal Err. (E-10:INTERNAL) Cause Remedy Front speakers are not detected. One of the surround speakers cannot be detected. Exit YPAO, turn off the unit, and then check the speaker connections. The noise is too loud. Keep the room quiet and retry YPAO. If you select "PROCEED", YPAO takes the measurement again and ignores any noise detected. The YPAO microphone has been removed. Connect the YPAO microphone to the YPAO MIC jack firmly and retry YPAO. The YPAO microphone cannot detect test tones. Connect the YPAO microphone to the YPAO MIC jack firmly and retry YPAO. If this error occurs repeatedly, contact the nearest authorized Yamaha dealer or service center. The measurement has been canceled. Retry or exit YPAO as necessary. An internal error has occurred. Exit YPAO, and turn off and on the unit. If this error occurs repeatedly, contact the nearest authorized Yamaha dealer or service center. • Texts in parentheses denote indicators on the front display. PREPARATIONS ➤ Optimizing the speaker settings automatically (YPAO) En 31